The most expensive mistake with spare parts is the wrong part: a part that arrives late, does not fit and is returned prolongs downtime. Konht Makine provides support in the supply of spare parts for Haitian plastic injection molding machines and auxiliary equipment. The information below helps us identify the right part the first time.
What is needed for part verification
- Machine model and serial number: The information on the nameplate shows which configuration the part belongs to.
- Label or code of the old part: A clear photo of the manufacturer, code and size markings on the part.
- Location of the part on the machine: Which of the clamping, injection, hydraulic, cooling or electrical/control units it belongs to.
- Dimensions: Part-specific measurements such as diameter, length, thread and pitch.
- Electrical specifications: Information such as voltage, power, current and connector type.
- Fault symptom: Why the part needs to be replaced and, if any, the error code.
Pre-order checklist
- I noted the machine model and serial number.
- I photographed all sides of the old part and its label.
- I measured the part and wrote down the dimensions.
- If it is an electrical part, I read the voltage and power values.
- I indicated the location of the part on the machine and its mounting position.
- I indicated the urgency and possible alternative solutions.
- I set the old part aside to compare it with the new one on delivery.
Additional information by part type
| Part group | Additional information that is useful to share |
|---|---|
| Screw, barrel, nozzle | Screw diameter, screw length, barrel inner diameter, nozzle tip size, material processed |
| Heater band, thermocouple | Inner diameter, width, voltage, power, thermocouple type and length, connection type |
| Hydraulic seal, hose, filter | Inner and outer diameter, cross-section, material, working pressure, connection size |
| Sensor, valve, board | Label code, signal type, output type, connector and pin configuration |
The same logic applies to auxiliary equipment (granulators, dryers, loaders, chillers and mold conditioning systems). You can browse our part categories on the spare parts page.
If there is no old part or its label has worn off, we can also assess the part based on the machine's operating condition, its function and the connections around it; in this case, the machine information and photos become even more important. When there is any doubt about the part, verifying it before placing an order prevents loss of time and money.
Part orders and information
Availability, price and delivery information vary by part; we confirm this information in writing after receiving your request. Simply send the information from the checklist via the contact page. For a more detailed guide, see our article Checklist for finding the right part when ordering spare parts.
